Vertical press "Odzhur-7" (PVH80)

The press hydraulic vertical openwork -7 is designed for hot stamping (forging) products of ferrous metals, manufacturing decor items

From sheet metal up to 1.5 mm thick, by cutting down and subsequent molding.

The capabilities of the hydraulic vertical press "Open-7" allow:

- make goose legs of rods of square and round section up to 40 mm;

- make peaks from rods of square and round section from 8 to 40 mm;

- make a squeeze of the faces of the square of the square section from 8 to 40 mm;

- produce a decorative squeeze of the rod of square and round cross section from 8 to 22 mm and standard planes of 40-60 mm.

.

Hydraulics on the vertical press "Odzhur-7" is located from below, which eliminates oil from hot blanks during forging.